Table of Contents
Advertisement
Use Power-Save Mode
To maximize the life of your DVR, you should power-down the DVR when it is
not in use. Simply press CBL and then press Power on your remote control,
or press Power on the front panel of the DVR. The Power light turns off , but
because the DVR still is plugged in, your scheduled recordings still occur.
Between 1:00 a.m. and 6:00 a.m. every day,
your DVR will automatically enter Power-Save
mode. In Power-Save mode, the set-top is
powered-down, but all scheduled recordings
still occur. When the DVR enters Power-Save
mode, your TV displays a black screen.
At approximately 1:10 a.m., the DVR displays a
5-minute warning banner, which states that the
DVR is about to enter Power-Save mode. When
the banner appears, do one of the following:
•
To allow the DVR to enter Power-Save mode, do nothing when the
warning banner appears. The DVR will automatically power-down. After
your DVR powers down, you must press CBL and then press Power on
your remote control, or press Power on the front panel of your DVR to
start watching TV again.
•
To stop the DVR from entering Power-Save mode, simply press any key
on your remote control when the warning banner appears.
From 1:10 a.m. through 6:00 a.m., the DVR displays the warning banner
if you do not press a key on the remote control or the front panel within 2
hours.
Attention
Your DVR will automatically enter power-save mode in 5 minutes.
Press any remote key to continue watching TV.
15
Advertisement
Table of Contents
