Cisco Explorer 8000 Getting Started Manual page 6

4. Choose one of the following options:
• If you have a standard-screen (4:3)
HDTV, press
• If you have a wide-screen (16:9)
HDTV, press
5. Choose one of the following options:
• To choose the Quick Setup option
A
press
television.
• To choose the Standard Setup option press
screen instructions. When you fi nish, press
press
• To choose the Custom Setup option, press
screen instructions. When you fi nish, press
press
Setting Up Your Explorer 8000HD DVR With an SDTV
If you have a standard-defi nition TV (SDTV), use the composite outputs to
connect the DVR to your TV. Refer to the Explorer 8000 Home Entertainment
Server User's Installation Guide (part number 4002771) for connection
information.
Follow these steps to start the Setup Wizard.
1. Make sure that the Explorer DVR is Off and the TV is On.
2. On the Explorer DVR, press Guide and Info at the same time. The TV
Connection Set-up screen appears, and the front panel LED displays
either HD-1 or SD-1. This LED changes between HD-1 and SD-1 every
few seconds.
3. When the front panel LED displays SD-1, press
watching television.
6
A
.
B
.
. Press to begin watching
to begin watching television.
to begin watching television.
B
; then follow the on-
to exit the setup. Then
; then follow the on-
to exit the setup. Then
. Press to begin