Cisco Explorer 8700 Cable DVR Family Set-Tops Quick Reference Manual

IMPORTANT SAFETY INSTRUCTIONS
Notice to Installers
The servicing instructions in this notice are for use by qualifi ed service personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions, unless you are qualifi ed to do so.
Note to System Installer
For this apparatus, the coaxial cable shield/screen shall be
grounded as close as practical to the point of entry of the cable
into the building. For products sold in the US and Canada, this
reminder is provided to call the system installer's attention to
Article 820-93 and Article 820-100 of the NEC (or Canadian
Electrical Code Part 1), which provides guidelines for proper
grounding of the coaxial cable shield.
This symbol is intended to alert you that uninsulated voltage
within this product may have sufficient magnitude to cause
electric shock.Therefore, it is dangerous to make any kind of
contact with any inside part of this product.
Ce symbole a pour but d'alerter toute personne qu'un contact
avec une pièce interne de ce produit, sous tension et non isolée,
pourrait être suffisant pour provoquer un choc électrique. Il est
donc dangereux d'être en contact avec toute pièce interne de
ce produit.
1) Read these instructions.
2) Keep these instructions.
WARNING: Avoid electric shock and fi re hazard! Do not
3) Heed all warnings.
locate an outside antenna system in the vicinity of overhead power
4) Follow all instructions. lines or power circuits. Touching power lines or circuits might be fatal.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance
with the manufacturer's instructions.
8) Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers)
that produce heat.
9) Do not defeat the safety purpose of the polarized or
Ground Clamps
grounding-type plug. A polarized plug has two blades with
one wider than the other. A grounding-type plug has two
blades and a third grounding prong. The wide blade or the
third prong are provided for your safety. If the provided
plug does not fit into your outlet, consult an electrician for
Electric Service
replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
NEC = National Electrical Code 1990
National Fire Protection Association
11) Only use attachments/accessories specified by the
manufacturer.
TO CATV INSTALLER
This reminder is provided to call the CATV system installer's attention
12) Use only with the cart, stand, tripod, bracket, or
to Article 820-40 of the National Electrical Code (NEC) that provides
table specified by the manufacturer, or sold with the
guidelines for proper grounding, and in particular, specifies that the
apparatus. When a cart is used, use caution when
cable ground shall be connected to the grounding system of the
moving the cart/apparatus combination to avoid injury from building, as close to the point of entry as practical.
tip-over.
13) Unplug this apparatus during lightning storms or when Protect the Product from Lightning
unused for long periods of time.
In addition to disconnecting the AC power from the wall outlet, disconnect
14) Refer all servicing to qualified service personnel. Servicing
the signal inputs.
is required when the apparatus has been damaged in any
Verify the Power Source from the On/Off
way, such as a power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the apparatus,
Power Light
the apparatus has been exposed to rain or moisture, does
When the on/off power light is not illuminated, the apparatus may still be
not operate normally, or has been dropped.
connected to the power source. The light may go out when the apparatus is
turned off , regardless of whether it is still plugged into an AC power source.
Power Source Warning
A label on this product indicates the correct power source for this product.
Eliminate AC Power/Mains Overloads
Operate this product only from an electrical outlet with the voltage and
frequency indicated on the product label. If you are uncertain of the type
of power supply to your home or business, consult your service provider
or your local power company.
WARNING: Avoid electric shock and fi re hazard! Do not
The AC inlet on the unit must remain accessible and operable at all times. overload AC power/mains, outlets, extension cords, or integral
convenience receptacles. For products that require battery power
Ground the Product or other power sources to operate them, refer to the operating
instructions for those products.
Handling Disposable Batteries
WARNING: Avoid electric shock and fi re hazard! If this product
This product may contain disposable batteries. Heed the following warning
connects to coaxial cable wiring, be sure the cable system is grounded
and follow the Battery Safety and Battery Disposal instructions below.
(earthed). Grounding provides some protection against voltage surges
and built-up static charges.
Outdoor Grounding System
WARNING: There is danger of explosion if the battery is
mishandled or incorrectly replaced. Replace only with the same
If this product connects to an outdoor antenna or cable system, be sure
the antenna or cable system is grounded (earthed). This provides some type of battery. Do not disassemble it or attempt to recharge it
outside the system. Do not crush, puncture, dispose of in fi re,
protection against voltage surges and built-up static charges.
short the external contacts, or expose to water or other liquids.
Article 810 of the National Electric Code (NEC) ANSI/NFPA No. 70-1990,
Dispose of the battery in accordance with local regulations and
provides the following information:
instructions from your service provider.
• Grounding of the mast and supporting structure
Battery Safety
• Grounding the lead-in wire to an antenna discharge unit
• Insert batteries correctly. There may be a risk of explosion if the batteries
• Size of the grounding conductors
are incorrectly inserted.
• Location of the antenna-discharge unit
• Do not attempt to recharge 'disposable' or 'non-reusable' batteries.
• Connection to grounding electrodes
• Please follow instructions provided for charging 'rechargeable' batteries.
• Requirements for the grounding electrodes (see the following antenna
• Replace batteries with the same or equivalent type that we recommend.
grounding diagram as recommended by NEC ANSI/NFPA 70)
CAUTION: To reduce the risk of electric shock, do not
remove cover (or back). No user-serviceable parts
inside. Refer servicing to qualified service personnel.
WARNING
TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS UNIT TO RAIN OR MOISTURE.
This symbol is intended to alert you of the presence
of important operating and maintenance (servicing)
instructions in the literature accompanying this product.
Ce symbole a pour but de vous avertir qu'une
documentation importante sur le fonctionnement et
l'entretien accompagne ce produit.
20080814_Installer820
• Do not expose batteries to excessive heat (such as sunlight or fi re).
• Do not expose batteries to temperatures above 100°C (212°F).
Battery Disposal
• The batteries may contain substances that could be harmful to the
environment.
• Recycle or dispose of batteries in accordance with the battery
manufacturer's instructions and local/national disposal and recycling
regulations.
Antenna Lead In Wire
• The batteries may contain perchlorate, a known hazardous substance,
so special handling and disposal of this product might be necessary. For
more information about perchlorate and best management practices
Antenna Discharge
for perchlorate-containing substance, see www.dtsc.ca.gov/
Unit
hazardouswaste/perchlorate
(NEC Section 810-21)
Grounding
Provide Ventilation and Select a Location
Conductors
(NEC Section 810-20)
• Remove all packaging material before applying power to the product.
Equipment
Ground Clamps
• Do not place this apparatus on a bed, sofa, rug, or similar surface.
• Do not place this apparatus on an unstable surface.
Power Service
• Do not install this apparatus in an enclosure, such as a bookcase or rack,
Grounding
unless the installation provides proper ventilation.
Electrode System
(NEC Art 250, Part H)
• Do not place entertainment devices (such as VCRs or DVDs), lamps,
books, vases with liquids, or other objects on top of this product.
• Do not block ventilation openings.
Operating Environment
The set-top is designed for operation indoors with a temperature range from
32° to 104° F (0° to 40°C). Each set-top should have adequate spacing
on all sides so that the cooling air vents on the chassis are not blocked.
Protect from Exposure to Moisture and Foreign
Objects
WARNING: Avoid electric shock and fi re hazard! Do not
expose this product to dripping or splashing liquids, rain, or moisture.
Objects fi lled with liquids, such as vases, should not be placed on
this apparatus.
WARNING: Avoid electric shock and fi re hazard! Unplug
this product before cleaning. Do not use a liquid cleaner or an
aerosol cleaner. Do not use a magnetic/static cleaning device (dust
remover) to clean this product.
WARNING: Avoid electric shock and fi re hazard! Never
push objects through the openings in this product. Foreign objects
can cause electrical shorts that can result in electric shock or fi re.
Service Warnings
WARNING: Avoid electric shock! Do not open the cover
of this product. Opening or removing the cover may expose you
to dangerous voltages. If you open the cover, your warranty will be
void. This product contains no user-serviceable parts.
Check Product Safety
Upon completion of any service or repairs to this product, the service
technician must perform safety checks to determine that this product is in
proper operating condition.
Cisco Explorer 8700 Cable DVR Family Set-Tops
Protect the Product When Moving It
Always disconnect the power source when moving the apparatus or
connecting or disconnecting cables.
20110316_Cable_Safety
United States FCC Compliance
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed
AVC VIDEO LICENSE
to provide reasonable protection against such interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
With respect to each AVC/H.264 product, we are obligated to provide
energy. If not installed and used in accordance with the instructions, it may
the following notice:
cause harmful interference to radio communications. However, there is no
THIS PRODUCT IS LICENSED UNDER THE AVC PATENT PORTFOLIO LICENSE
guarantee that interference will not occur in a particular installation. If this
FOR THE PERSONAL USE OF A CONSUMER OR OTHER USES IN WHICH IT
equipment does cause harmful interference to radio or television reception,
DOES NOT RECEIVE REMUNERATION TO (i) ENCODE VIDEO IN COMPLIANCE
which can be determined by turning the equipment OFF and ON, the user is
WITH THE AVC STANDARD ("AVC VIDEO") AND/OR (ii) DECODE AVC VIDEO
encouraged to try to correct the interference by one or more of the following
THAT WAS ENCODED BY A CONSUMER ENGAGED IN A PERSONAL ACTIVITY
measures:
AND/OR WAS OBTAINED FROM A VIDEO PROVIDER LICENSED TO PROVIDE
• Reorient or relocate the receiving antenna.
AVC VIDEO. NO LICENSE IS GRANTED OR SHALL BE IMPLIED FOR ANY OTHER
• Increase the separation between the equipment and receiver. USE. ADDITIONAL INFORMATION MAY BE OBTAINED FROM MPEG LA, L.L.C.
SEE HTTP://WWW.MPEGLA.COM.
• Connect the equipment into an outlet on a circuit diff erent from that to
which the receiver is connected. Accordingly, please be advised that service providers, content providers,
and broadcasters may be required to obtain a separate use license from
• Consult the service provider or an experienced radio/television technician
MPEG LA prior to any use of AVC/H.264 encoders and/or decoders.
for help.
Any changes or modifi cations not expressly approved by Cisco Systems,
Inc., could void the user's authority to operate the equipment.
The information shown in the FCC Declaration of Conformity paragraph
below is a requirement of the FCC and is intended to supply you with
information regarding the FCC approval of this device. The phone numbers
listed are for FCC-related questions only and not intended for questions
regarding the connection or operation for this device. Please contact your
service provider for any questions you may have regarding the operation or
installation of this device.
Declaration of Conformity
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affi liates in the U.S. and other countries. A listing of Cisco's trademarks can be
found at www.cisco.com/go/trademarks.
This device complies with Part 15 of FCC Rules. Operation is subject
CableCARD and M-Card are trademarks of Cable Television Laboratories, Inc.
to the following two conditions: 1) the device may not cause harmful
interference, and 2) the device must accept any interference received,
Manufactured under license from Dolby Laboratories. Dolby is a trademark of Dolby Laboratories.
including interference that may cause undesired operation.
HDMI, the HDMI logo, and High-Defi nition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC in the United States and other
countries.
MoCA is a trademark of the Multimedia over Coax Alliance.
Canada EMI Regulation
Rovi is a trademark of Rovi Corporation.
Other third party trademarks mentioned are the property of their respective owners.
This Class B digital apparatus complies with Canadian ICES-003.
The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1009R)
Cet appareil numérique de la class B est conforme à la norme NMB-003
© 2011, 2012 Cisco and/or its affi liates. All rights reserved.
du Canada.
July 2012
SELECT
VOL
Explorer ® 8742HDC
ROVI CORPORATION COPYRIGHT NOTICE
Cisco Explorer 8700 Cable DVR Family Set-Tops
This product incorporates copyright protection technology that is protected
Manufactured by:
by U.S. patents and other intellectual property rights of Rovi Corporation.
Cisco Systems, Inc.
Use of this copyright protection technology must be authorized by Rovi
5030 Sugarloaf Parkway
Corporation, and is intended for home and other limited viewing uses only
Lawrenceville, Georgia 30044 USA
unless otherwise authorized by Rovi Corporation. Reverse engineering and
Telephone: 678 277-1120
disassembly are prohibited.
20081121 FCC Standard
Disclaimer
Cisco Systems, Inc. assumes no responsibility for errors or omissions that
may appear in this guide. We reserve the right to change this guide at any
time without notice.
Cisco Systems, Inc.
5030 Sugarloaf Parkway, Box 465447
Lawrenceville, GA 30042
Quick Reference Guide
CH
VOL
CH
678 277-1120
770 722-2009
www.cisco.com
Part Number 4038345 Rev C