American standard shower system kit specification sheet (2 pages)
Summary of Contents for American Standard 1662 Series
Page 1
Apply sealant or teflon tape to threads of 1/2" NPT supply nipple. Thread WALL SUPPLY (1) onto supply nipple making a water tight seal. WALL SUPPLY (1) with RUBBER SEAL (2) should be tight against finished wall. Installation Instructions 1662 SERIES Hammer Pencil 1498mm (59") 1660.500...
Page 2
INSTALL LOWER SUPPORT BRACKET The SLIDE BAR works best when secured to the wall studs or cross brace using the WOOD SCREWS. If a mounting into the studs is not possible, use appropriate wall fasteners to provide secure installation. Mark a vertical center line in the location you wish to install the SLIDE BAR.
Page 3
INSTALL SLIDE BAR INTO MOUNTING BRACKETS Install the SLIDE BAR (1) back into the lower MOUNTING BRACKET (2). IMPORTANT: The slot at the bottom of the slide bar must face toward the wall. Rotate the slide bar until it locks into place and cannot be turned.