American Standard Personal Shower System 1660.100 Series Installation Instructions
American Standard Personal Shower System 1660.100 Series Installation Instructions

American Standard Personal Shower System 1660.100 Series Installation Instructions

Personal shower system

Advertisement

Installation Instructions for:
ROUGHING-IN DIMENSIONS
DELUXE SHOWERHEAD
BODY SIDE SPRAY
1/2" S.P .S.
24"
32" OPTIONAL
TO FINISHED
28" OPTIONAL
FLOOR
TO FINISHED
- 2 SPRAY
1

ROUGHING-IN

Prepare shower connection nipples per roughing-in
dimensions. See diagram for recommended 2 and 3
BODY SIDE SPRAY installation.
2

SHOWERHEAD INSTALLATION

Slide ESCUTCHEON forward and compress
BELLOWS to expose supply connectors.
Use adjustable wrench to install SHOWERHEAD.
SUPPLY
CONNECTOR
REGULATOR
ESCUTCHEON
AND
BELLOWS
P r i n t e d i n W e s t G e r m a n y
30449
A M A R I L I S ™
TM
P e r s o n a l S h o w e r S y s t e m
1-1/2"
OPTIONAL TO
FINISHED FLOOR
USUALLY 65" TO 78".
FOR USE WITH BODY
SIDE SPRAYS 72" TO 78"
IS RECOMMENDED.
FINISHED
WALL
1-1/2"
1/2"
SEE
MAX.
RECOMMENDED
INSTALLATION
BELOW
TO SHOWERHEAD
16"
3 HANDLE
B/S VALVE
16"
TWO-WAY
FLOOR
DIVERTER
VALVE
- 3 SPRAY
COUPLING
NUT
FLOW
DEL UXE SHO W ER HEA D
BO DY S I DE SPR AY
FINISHED
WALL
1/2"
MAX.
6-1/2"
RECOMMENDED INSTALLATION FOR
MULTIPLE BODY SIDE SPRAYS:
4-3/4"
4"
TUB SPOUT
Cap nipples, turn on water supplies and check for leaks.
Turn on water supplies and check for leaks.
Push ESCUTCHEON back until seated flush against
wall.
3

SERVICE

To increase swivel tension:
Compress BELLOWS towards rear to expose ball joint.
Wrench tighten COUPLING NUT to increase tension.
The FLOW REGULATOR may accumulate debris causing
reduced water flow. To clean, remove SHOWERHEAD,
then:
Remove ESCUTCHEON and BELLOWS.
Unscrew SUPPLY CONNECTOR to remove FLOW
REGULATOR.
Clean FLOW REGULATOR, re-assemble and install
SHOWERHEAD.
A l l p r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A m e r i c a n S t a n d a r d I n c .
A m e r i c a n S t a n d a r d I n c . 1 9 9 0
C
1660.100 SERIES
1660.120 SERIES
Each installed BODY SIDE SPRAY requires
2.5 GPM for an adequate spray flow.
For maximum flow, use Amarilis 3-Handle
Bath/Shower Valve 8030 or 8031 Series.
Connect multiple body side sprays to spout
outlet of valve.
Provide two-way diverter valve for addition of
tub spout.
Connect deluxe showerhead to shower outlet
of valve.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Personal Shower System 1660.100 Series and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Amarilis 1660.120 series

Table of Contents