Using The Sharp Twain - Sharp AL-1216 Operation Manual

4
Press the start (
The selected application launches and scanning begins.
If the following dialog box appears in Windows 98, Button Manager is not
set for use in Windows. Set up Button Manager for use in Windows as
explained in "Setting up the Button Manager" (p.56).
If the following screen appears, select Button
Manager and click "OK". Button Manager starts
and the application associated with Button
Manager starts. If you want only Button Manager
to start in this case, set up Button Manager for
use in Windows as explained in "Setting up the
Button Manager" (p.56).
Opening the scanner driver and scanning from your computer
Follow the steps below to open the scanner driver setup screen. As an example, this
instruction is given using Sharpdesk as an image capture application.
• Scanning is not possible during a copy and print job.
• The method for starting the scanner driver differs depending on the
type of application. Refer to the manual or the help file of your
application.
• When using the scanner driver to scan an original that has been
placed in the SPF. If you perform a pre-scan (see the online manual or
the help file for the scanner driver), the original in the SPF will be
output to the exit area after scanning. To scan the original after the
pre-scan, place the original in the SPF once again.

Using the SHARP TWAIN

1
Place the original you wish to scan on the original table/SPF.
For the procedure for placing the original, see "ORIGINAL PLACEMENT"
(p.20).
2
After starting Sharpdesk, click the
"File" menu and select "Select
Scanner".
) key.
8
Click here
61