Acura 2008 MDX Owner's Manual page 71

Main Menu
Vehicle Stability Assist
(VSA) System Indicator
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position.
If it comes on and stays on at any
other time, or it does not come on
when you turn the ignition switch to
the ON (II) position, there is a
problem with the VSA system. You
will also see a ''CHECK VSA
SYSTEM'' message on the multi-
information display (see page
Take your vehicle to a dealer to have
it checked. Without VSA, your
vehicle still has normal driving ability,
but will not have VSA traction and
stability enhancement. For more
information, see page 359
This indicator may also come on if
there is a problem with the trailer
stability assist function (see page
).
375
Table Of Contents
VSA Activation Indicator
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. For more information, see
page .
359
This indicator has four functions.
1. It comes on as a reminder that you
have turned off the vehicle
stability assist (VSA) system.
2. It flashes when VSA is active (see
81 ). page 359
3. It flashes when trailer stability
assist is activating (see page
4. It comes on along with the VSA
. system indicator if there is a
problem with the VSA system.
You will also see a ''CHECK VSA
SYSTEM'' message and a
''CHECK TRAILER STABILITY
ASSIST'' message on the multi-
).
375 ).
2008 MDX
Instrument Panel Indicators
information display (see page
Turn Signal and
Hazard Warning
Indicators
The left or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see page 404
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the hazard warning
button, both turn signal indicators
and all turn signals on the outside of
the vehicle flash.
81 ).
). Replace
67