Acura 2008 MDX Owner's Manual page 282

Main Menu
HomeLink Universal Transceiver
6. Repeat these steps to train the
other two HomeLink buttons to
operate any other compatible
remotely controlled devices
around your home (lighting,
automatic gate, security system,
etc.).
Training With a Rolling Code
System
For security purposes, newer garage
door opening systems use a ''rolling''
or variable code. Information from
the remote control and the garage
door opener is needed before
HomeLink can operate the garage
door opener.
The ''Training HomeLink''
procedure trains HomeLink to the
proper garage door opener code.
The following procedure
synchronizes HomeLink to the
garage door opener so it sends and
receives the correct codes.
278
Table Of Contents
1. Make sure you have properly
completed the ''Training
HomeLink'' procedure.
2. Find the ''training'' button on your
garage door opener unit. The
location will vary, depending on
the manufacturer.
3. Press the training button on the
garage door opener unit until the
indicator next to the button comes
on. The indicator may blink, or
come on and stay on. You then
TRAINING BUTTON
2008 MDX
have approximately 30 seconds to
complete the following steps.
4. Press and hold the button on
HomeLink for 3 to 4 seconds.
5. Press and hold the HomeLink
button again for 3 to 4 seconds.
This should turn off the training
indicator on the garage door
opener unit. (Some systems may
require you to press the button up
to three times.)
6. Press the HomeLink button again
for about 1 second. It should
operate the garage door.