Table 3-2 Bps Leds; Table 3-3. Pci Power Supply Leds - HP RP7405/7410 User Manual

Troubleshooting
Common Installation Problems
Table 3-1 Front Panel LEDs (Continued)
LED
Run
Fault
Bulk Power Supply LEDs
There is a single three-color LED on each bulk power supply.
Table 3-2 BPS LEDs
LED Indication
Blink Green BPS in standby state and no faults or warnings
Green BPS in run state (48 volt output enabled) and no faults or
warnings
Blink Yellow BPS in standby or run state and warning(s) present but no faults
Yellow BPS in standby state and recoverable fault(s) present but no
non-recoverable faults
Blink RED BPS state may be unknown, non-recoverable fault(s) present
Red Not Used (therefore BPS Failure)
Off BPS state unknown, (therefore BPS Fault or Failure)
PCI Power Supply LEDs
There are three LEDs on the PCI power supply. Green and yellow LEDs follow OL* operation. A multi-color
LED reports warnings and faults.
Table 3-3 PCI Power Supply LEDs
LED Driven By
Power Each Supply
Attention SP via PCI LPM
52
Driven By State
PDC/SP via On Green
GPM
Off
PDC/SP via Flash Red
GPM
Off
State
On Green
Off
Yellow
One or more partition running
No partition running, or SP not installed, or SP
installed and not active
One or more Partitions have reported a fault
No Partitions running, or SP not installed, or SP
installed and not active
Description
Description
All output voltages generated by the power
supply are within limits.
Output voltages are turned off
See Table 3-7.
Description
Chapter 3