Table of Contents
Advertisement
Installation
This section provides instructions for installing the CS 26T speakers and the CS 120P
enclosure. Topics include:
•
•
•
•
•
•
Installation Considerations
WARNING:
•
•
•
Installation Configurations
The CS 26T can be configured in the following ways:
•
•
For hard ceiling installations, see
page 26.
Installation Considerations
Installation Configurations
Installing the CS 1226T — Single Installer
Installing the CS 120P in a Suspended Ceiling — Division of Labor
Installing the CS 26T in a Suspended Ceiling — Division of Labor
Installing CS 120P in a Hard Ceiling
Risk of severe bodily injury from falling or sharp equipment.
Installation and service must be performed by authorized personnel only.
All wiring and electrical connections must conform to all applicable building codes and
local ordinances.
Installation in a plenum-rated environment requires plenum rated cable or conduit.
If using secondary support cables, the installer provides the cables.
Open-back: For configurations in which the CS 120P is not used, use the C-ring
accessory, available at www.extron.com. The C-ring spreads out the clamping force of
the dog-legs when used in drop ceilings and gypsum ceilings.
Using the CS 120P: When used with the CS 120P, the CS 26T can be placed in
plenum environments. This is the only configuration that is UL 2043 rated.
NOTE: The CS 120P can be ordered separately or as part of the CS 1226T kit.
Installing the CS 120P in a Hard Ceiling
CS 26T and CS 120P User Guide • Installation
on
3
Advertisement
Table of Contents
