Hardware Installation - Mitsubishi Electric Diamond Digital DV173BP User Manual

4
4

Hardware Installation

Your monitor is equipped with an automatic power supply with a voltage range
from 100 to 240 Volts AC at a frequency of 50 to 60 Hz. Make sure that your
local power supply is within the supported range. If you are unsure, please
contact your electricity supplier.
To install your Diamond Digital DV173BP monitor:
1. Make sure that the power to the computer and the power to the monitor are
both turned off.
2. Connect the blue connector of the monitor's D-sub cable to the VGA output
of the computer's graphics card.
3. Connect the stereo audio cable from the monitor's audio jack to the audio
output of your computer's sound card.
4. Connect the power cord from the monitor's power jack to an AC power
socket. Please make sure, that you have easy access to the power socket
so you can disconnect the unit from the power socket should you need to.
1.
Power cable
2.
Video cable
3.
Audio cable
4