Installing the SCSI Miniport Driver
Device Driver Installation
This section describes the instructions for installing the Windows SCSI Miniport
driver.
System Requirements
Ensure that your system meets these minimum requirements:
Installing or Upgrading a New Driver
The AB232A HBA is a plug-and-play device that is detected by Windows
operating systems. Perform the following steps to add or update the Windows
driver to a previously installed Windows system:
1. Install the HBA as described in
2. Restart or turn on the computer.
3. Browse to the the driver kit on the Smart Setup CD-ROM (or one you
4. Double-click cp00xxxx.exe.
Note:
final version number:
http://h18000.www1.hp.com/storage/saninfrastructure.html.
5. Follow the installation wizard instructions.
6. When the installation completes, you must reboot.
7. Repeat
26
Installed HBA
StorageWorks Fibre Channel Storage subsystem (interconnect device and
storage device)
downloaded from the website if it is more recent).
Refer to the following website for the information about this Smart Component's
step 1
through
after installing the driver for the last HBA.
Chapter 2
on page 17.
step 6
for any additional HBAs. Make sure to reboot
AB232A PCI-X Host Bus Adapter Installation Guide