Pride Quantum 6000Z series Owner's Manual page 23

Power Elevating Seat Installation
Your power chair may be equipped with the power ele-
vating seat option. While the seat itself may be any one
of the styles offered for this model, the way the seat
base attaches to the power base is different.
To install the power seat:
l. Place the seat plate interface bracket onto the actu-
ator. See figure 14.
2. Insert screws into the actuator and insert and
tighten the hardware. See figure 14.
3. Place seating system onto the seat plate interface
bracket and secure.
Transit Securement System (Optional)
If your power chair is equipped with a transit
securement system, it is equipped with manufacturer-
installed front and rear securement brackets and
positioning belt anchoring brackets. See figure 15.
Refer to the supplement provided with your power
chair for information on how to use the transit
securement system.
NOTE: In certain configurations, the transit
securement system is not available on power chairs
equipped with an HD option.
SEAT PLATE INTERFACE BRACKET
ACTUATOR
Figure 14. Power Seat Actuator
Quantum 6000Z Series
I V . A S S E M B L Y
www.pridemobility.com
WIRE TIES
Figure 13. Controller Routed on a Contour Seat
POSITIONING BELT
ANCHORING BRACKET LOCATIONS (1 OF 2 SHOWN)
Figure 15. Transit System Securement Brackets
SECUREMENT
BRACKETS
(3 OF 4 SHOWN)
23