Pride Mobility QUANTUM SERIES Owner's Manual page 38

V I I . C A R E A N D M A I N T E N A N C E
To replace the batteries:
1. Turn off the power to the controller.
2. Make sure that the power chair is in drive mode. See III. "Your Power Chair."
3. Remove the foot platform by squeezing the release handles (see figure 27) and lifting the foot platform bracket
up and away from the power base.
4. Disconnect the quick release battery connectors. See figure 7.
5. Remove the batteries.
6. Disconnect the battery harness from each battery.
7. Connect the battery harness to the new front battery according to the battery wiring diagram. See figure 27.
WARNING! Make sure you tighten the fasteners so that the connections are secure.
8. Connect the battery harness to the new rear battery according to the battery wiring diagram. See figure 27.
9. Install the new batteries.
10. Reinstall the front cover and foot platform.
11. Charge the batteries. See VI. "Batteries and Charging."
REAR SHROUD FASTENER
(OPPOSITE SIDE NOT SHOWN)
Figure 27. Battery Installation
38
REAR SHROUD
www.pridemobility.com
BATTERY WIRING DIAGRAM LABEL
REAR BATTERY
FRONT COVER
RELEASE HANDLES
FRONT BATTERY
Quantum 6000 Series