Troubleshooting Eprom Installation - Allied Telesis Rapier 16fi Hardware Reference Manual

Hardware Reference
C613-03020-00 REV K
Figure 32: Example output from the SHOW INSTALL command
Install Release
------------------------------------------------------------
Temporary -
Preferred flash:load\86s-210.rez
Default EPROM (86s-2.1.0)
------------------------------------------------------------
Current install
------------------------------------------------------------
Preferred flash:load\86s-210.rez
------------------------------------------------------------
Install history
------------------------------------------------------------
No Temporary install selected
Preferred install selected
Preferred release successfully installed
------------------------------------------------------------

Troubleshooting EPROM Installation

If the switch fails to reboot or functions incorrectly, then the most likely cause is
that there is a problem with the way the boot EPROMs were installed. Repeat
the installation procedure, checking:
• That the boot EPROMs are in the correct locations and oriented
correctly (using the relevant location diagram as a guide).
• For bent pins. These should be carefully straightened.
If the switch still fails to reboot, replace the new boot EPROMs with the
original set and contact your Authorised Allied Telesis distributor or reseller.
Patch
-
-
-
-
63