Recording A New Ogm (Outgoing Message); Changing Ogm Mode (1 Or 2) - Panasonic EASA-PHONE KX-T2470 Operating Instructions Manual

Direct Remote Operation (cont.)
Recording a new OGM (Outgoing Message)
You can change the content of your OGM tape from a remote telephone.
Callyour unit.
Example
r t m w t
t] ] t9_]
Re-recording OGM 1
Changing OGM mode (1 or 2)
You can change your OGM mode.
From OGM 1 to OGM 2
Callyour unit.
1
D i a l y o u r c o de n u m b e r ( f o r
e x a m p l e , 1 9 ) w h i le t h e O G M is
p l a yi n g .
The unit announces the number of newlv
recorded messages.
Press "7" to reset the tape.
"Recording OGM one" will be announced.
A series of short beeps will be heard
continuously until the OGM tape has been
reset followed by a long beep.
Speak immediately after the long
beep.
Do not pause lor over 2 seconds.
lf you hear 6 beeps and the announcement
"Please record your
Outgoing Message
again", start over again from step 3 within
5 seconds.
Press "9" when you finished.
The new OGM is played back for you to
check or amend.
Press "8" insteadof "7" al
step 3 of the above procedure.
"Recording
OGM two" will be announced.
- 4 9 -
Example
i-- l trwl
t]_J tll
t r :
Dial your code number (for
e x a m p l e , 1 9 ) w h i l e th e O G M i s
p l a y i n g .
The unit announces the number of newly
recorded messages.
Prgss ")c".
Press "8".
"Two" will be announceo.
The unit will play back OGM 2.
Press "7" instead of "8" at step 4
of the above procedure.
"One" will be announced.
The unit will play back OGM 1
From OGM 2 to 1
tMv]
L e l
Re-recording OGM 2
- 5 0 -