Power Connector Cable - HP PAVILION DV2700 Maintenance And Service Manual

When replacing the system board, be sure that the following components are removed from the defective
system board and installed on the replacement system board:
ExpressCard assembly (see
●
Fan/heat sink assembly (see
●
Processor (see
●
Reverse the preceding procedure to install the system board.

Power connector cable

Description
Power connector cable for use in computer models with Intel processors
Power connector cable for use in computer models with AMD processors
Before removing the power connector cable, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Remove the following components:
5.
Hard drive (see
a.
Optical drive (see
b.
Keyboard (see
c.
Switch cover (see
d.
Display assembly (see
e.
Top cover (see
f.
System board (see
g.
Remove the power connector cable:
Remove the Phillips PM2.5×5.0 screw (1) that secures the connector frame to the base enclosure.
1.
108 Chapter 4 Removal and replacement procedures
ExpressCard assembly on page
Fan/heat sink assembly on page
Processor on page 115)
Battery on page
Hard drive on page
Optical drive on page
Keyboard on page
Switch cover on page
Display assembly on page
Top cover on page
System board on page
109)
112)
56).
61)
73)
74)
79)
82)
87)
106)
Spare part number
448628-001
430462-001