Indicator Lights And Error Codes; Service Indicator Lights - Kodak i1400 Series Maintenance Manual

Problem
Documents are multifeeding
Roller marks or streaks appear on
documents after scanning
Vertical lines appear on the image
Received an unexpected error from the
scanner
Indicator lights and
error codes
Service indicator
lights
A-61550 February 2010
Make sure that:
• the leading edges of all batched documents are centered in the feeder
so that each document will come in contact with the feed rollers.
• the feed module and separator module are clean and not worn.
• documents with an unusual texture or surface are fed manually.
Clean the feed module, separator module and rollers. Refer to Chapter
5, Maintenance.
• Clean the imaging guides. Refer to Chapter 5, Maintenance.
This error should rarely be seen, but if it does do the following:
• power off the scanner
• restart your PC
• power on the scanner
• try again
If this problem persists, contact Service.
The indicator lights provide information on the current state of the
scanner.
Steady green: indicates the scanner is ready to scan.
Flashing green: indicates the scanner is scanning or in power saver
mode.
Steady red: indicates a scanner error, such as the scanner cover is
open.
Steady red and green — scanner is powering up.
After you power up the scanner, the red and green indicator lights will
illuminate. After approximately one minute, both lights go out. When the
green indicator light comes back on, the scanner is ready to begin
scanning. However, the host computer may require several seconds to
detect the scanner.
After you power up the scanner both LEDs are on.
Red: CPU not running code. The red indicator will go out after about 30
seconds. This indicator will always be off, unless you are downloading
firmware, calibrating the scanner, the cover is opened or there is an
error condition.
Green: the green indicator is on at all other times.
Possible Solution
Red indicator
Green indicator
6-3