Paw Active (Hp Authorized Service Providers Only); Figure 42 - Paw Active Removal - HP OmniBook 800CT Service Manual

Paw Active
(HP Authorized Service Providers Only)
Required Equipment
Torx #6 screwdriver
5mm hexdriver (F1171 - F1175 only)
Removal Procedure
1. Follow the Logic Board PCA Removal Procedure to gain access to the Paw Active.
2. Remove the Paw Shield. Refer to Figure 42 for location of components.
Paw Eject Arm
(p/n F1170-40008)

Figure 42 - Paw Active Removal

3. The Paw Eject Arm and Paw Eject Spring may be removed at this point for convenience.
4. Lift the Paw Active from the plastic posts holding it in place.
Replacement Procedure
1. To replace the Paw Active, reverse the steps in the Removal Procedure.
To avoid damage to the OmniBook components, ensure the paw active flex
C
:
AUTION
cable is completely and squarely inserted into the zero insertion force
connector.
Paw Shield
(p/n F1170-00009)
Paw Active
(p/n F1170-60909)
Bottom Case
(p/n F1170-
60904
F1171 - F1175)
(p/n F1360-
60904
Paw Eject Spring
(p/n F1030-00016)
73