Figure 36 - Intel Inside Sticker Placement - HP OmniBook 800CT Service Manual

Figure 36 - Intel Inside Sticker Placement

2. Thread the Display Flex Cable(s) of the replacement Display through the opening in the Top
Case and "close" the assembly comprising of the Top Case and Display Assembly.
3. Firmly place the Display Flex Cables(s) into the connector(s) on the Logic PCA.
4. Snap the Top Case and Display assembly in place and replace the keyboard support screws.
Note – For F1360 only, the two long screws MUST be replaced before the short screw.
Use care when replacing the top case and display assembly so as not to
C
:
AUTION
pinch the display flex cables between the top case I/O backplane. Always
inspect the back seam of the OmniBook to ensure the cables are not
pinched.
5. Replace the remainder of the components and reboot.
66
Intel Inside
Sticker for
F1360 only
(p/n 7121-7455)
Intel Inside
Sticker for
F1171 - F1175
(p/n 5182-5113)