Using Can-Bus - Classe Audio CT-M300 Owner's Manual

using CAN-Bus CAN-Bus is controlled via the touchscreen of any Delta or CT series
component. There is no master component, so Delta/CT series systems where
two or more units have a touchscreen can be controlled through any of the
touchscreens. However, it is probably easiest to start using CAN-Bus through
just one.
CAN-Bus is accessed by pressing the menu button on the face of the unit or
remote, then the status button, followed by the more button.
The touchscreen will then display the CAN-Bus devices screen, which lists
connected Delta series components by model & serial number.
Highlighting a unit on the CAN-Bus devices screen identifies it as the target
unit. The front panel LEDs of the target unit will start flashing (unless you
highlight the unit that you are using to access CAN-Bus).
Once you have chosen the target unit press select. The target unit's LEDs will
stop flashing and the touch screen will list the CAN-Bus features available to it.
Some CAN-Bus features are shared by all models, some are specific to individual
models.
23