HP OmniBook 800 Getting Started Manual page 34

Starting Out with Your OmniBook
Special Features
8. If the ribbon cables are no longer tucked into the frame, then push them back
into the recessed openings with a paper clip, as shown below. Re-insert the
keyboard by engaging the four front tabs on the keyboard into the four slots in
the computer frame, pressing down on the keyboard as you insert the tabs.
Make sure the ribbon cables slide into the recessed openings and do not extend
under the keyboard.
9. Close the OmniBook, turn it over, and re-insert the five screws removed in
step 3. Do not over-tighten the screws—screw just until you feel resistance.
10. Insert the battery. Connect the ac adapter.
11. Press the reset button.
12. Install Windows and the original software on the new drive C using the
Recovery CD-ROM—see "If you need to reinstall Windows and original software"
under Troubleshooting. Also check the README file for instructions.
There are different procedures for Windows95 and Windows for
Workgroups.
For other operating systems, re-install the operating system from your own
source first, then load the OmniBook-specific software.
13. Restore the files you backed up from the old drive C. In Windows95, use the
Backup utility (Start, Programs, Accessories, System Tools, Backup, Restore
tab).
1-28