HP OmniBook 800 Getting Started Manual page 12

Starting Out with Your OmniBook
Setting Up
Pressing the reset button is similar to turning off a PC's power, then turning it back
on again. After this first time, you should not need to press the reset button often.
If you have an OmniBook floppy drive attached when you reset the OmniBook,
make sure there's no disk in the drive (unless you set the option in the System
Configuration Utility to boot only from the hard drive). As on a PC, if there's a disk
in the floppy drive, the OmniBook looks there first for its startup files.
1-6