Disabling The Remote Start System; Over And Under Rev Protection; Shut Down Inputs - Directed Electronics AutoCommand 20095 Owner's Manual

➜

disabling the remote start system

This feature allows your system's remote start unit to be
temporarily disabled to prevent the vehicle from being remote
started accidentally. This feature is useful if the vehicle is being
serviced or stored in an enclosed area. To disable the remote
start, move the shutdown toggle switch to the OFF position. The
switch can be installed in a location of your choice. Check with
your installer for recommended locations.
Location of Shutdown Switch____________________________
➜

over and under rev protection

The system monitors the engine speed and will automatically
shut the engine off if the RPMs rise above or fall below the
programmed levels. This feature prevents damage to the motor
due to fuel delivery system failures or other problems which may
cause the engine to race.
note: The system uses an input from the vehicle to sense
engine speed. This wire must be connected in order for
over and under rev protection to work.
➜

shut down inputs

This security system uses several inputs to shut down the remote
start operation of the motor or prevent remote start if certain
inputs are active. The two most important are hood and brake
inputs. The hood input will prevent the motor from starting, as
well as shut it down, any time the hood is opened. The brake
38
© 2005 directed electronics—all rights reser ved