Table of Contents
Advertisement
Installation and Setup
22
Note
If you are using PoE (802.3 af), power will automatically be supplied to the
camera through the network cable.
2.
Plug in the power supply. Use a screwdriver to first loosen the ~AC 24 V terminal
screws on the terminal block.
Note
To ease installation, the terminal block can be removed. The power
connections of the removable terminal block are not polarity-sensitive.
Connect either power lead to either connector terminal.
3.
Secure the power leads by tightening the terminal screws until snug.
4.
Plug the power supply into an appropriate power source.
Note
For secure installations, surface-mounted cables should be protected by
plastic or metal cable covers.
Note
If your installation involves a 24 V AC power source, then please wait
approximately 60 seconds after connecting to a power source for video to
appear on the local video out.
Caution
Installation must be performed by a qualified service technician. The
proper wire gauge for the distance and number of cameras must be
determined to maintain 24 V AC at each camera.
Caution
When powering the camera from 24 V AC, a UPS source should be
considered to ensure satisfactory performance.
Note
Connect power either from a 24 V AC source or CAT5 Ethernet connector
(PoE). It is not recommended to connect both power sources at the same
time.
Hide quick links:
Advertisement
Table of Contents
