Bluetooth Operation - Dual DXV3D Installation & Owner's Manual

OPERATION

Bluetooth Operation

Bluetooth Operation To connect a Bluetooth device, install and connect the BTM100
(sold separately). When connected to the DXV3D, the BTM100
supports HFP (hands-free prole), A2DP (advanced audio
distribution prole), AVRCP (audio video remote control prole)
and PBAP (phone book access profile).
Before you can use a Bluetooth device, it must be paired and
connected. Make sure that Bluetooth is activated on your device
before you begin the pairing process.
Pairing a Device The BTM100 Bluetooth interface module (sold separately)
broadcasts the pairing signal constantly when no devices are
currently connected. Complete the pairing sequence from your
Bluetooth device. Refer to the owner's manual for your device
for more details.
Once pairing is complete, the TALK button on the BTM100
will be illuminated in blue. The device name is "BTM100". No
password is required for pairing.
Note: The DXV3D can be in any mode of operation when pairing
is performed.
Disconnecting a Device
Press PAIR, then press "Disconnect" to disconnect the
currently-paired device. The unit must be disconnected from
the current device before beginning the pairing sequence for a
new device.
If you press PAIR when no device is connected, the unit will
show the list of previously-paired devices. Press any device
name to repair that device.
30