biodex 950-400 Operation Manual page 52

CONTENTS
declaration of conformity
emissions
Manufacturer's declaration electromagnetic emissions
The Gait Trainer 3 Treadmill is intended for use in the electromagnetic environment specified below.
The customer or the user of the Gait Trainer 3 Treadmill should assure that it is used in such an envi-
ronment
emission test
RF emissions CISPR 11
RF emissions CISPR 11
Harmonic distortion
EN 61000-3-2
Voltage fluctuations
and flickerEN 61000-3-3
Immunity
Manufacturer's declaration electromagnetic immunity
The Gait Trainer 3 Treadmill is intended for use in the electromagnetic environment specified below.
The customer or the user of the Gait Trainer 3 Treadmill should assure that it is used in such an envi-
ronment.
Immunity test
Electrostatic discharge
(ESD)
IEC 61000-4-2
Electrical fast
transients/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
ELECTROMAGNETIC COMPATIBILITY
compliance
Group 1
Class A
Class A
Complies
Iec 60601-1-2
test level
± 6 kV contact
± 8 kV air
± 2 kV for power lines
± 1 kV for
input/output lines
± 1 kV differential mode
± 2 kV common mode
— 13-2 —
electromagnetic environment
The Gait Trainer 3 Treadmill generates
RF energy only for its internal functions.
Therefore, its RF emission is very low and is not
likely to cause any interference in nearby
electronic equipment
The Gait Trainer 3 Treadmill is suitable for use
in all establishments other than domestic and
those directly connected to the public
low-voltage power supply network supplying
buildings used for domestic purposes.
Iec 60601-1-2 electromagnetic
compliance level environment – guidance
Contact ± 6 kV Floor should be wood,
Air ± 8 kV concrete or ceramic tiles.
If floor is covered with
synthetic material, the
relative humidity should
be at least 30%
Power ± 2 kV Mains power quality
Signal ± 1 kV should be that of a
typical commercial or
hospital environment
± 1 kV diff. mode Mains power quality
± 2 kV com. mode should be that of a
typical commercial or
hospital environment