Table of Contents
Advertisement
•
= Drying
•
= Anti-crease
By selecting the drying programme, the drying pro-
gramme phase icons corresponding to the phases making
up the programme are shown in the upper part of the
display. After having pressed button 8 only the icon of the
running phase stays on.
7.12: Washing programme phase icons
• Prewash
• Wash
• Rinses
• Drain
First use
• Ensure that the electrical and water connections
comply with the installation instructions.
• Remove the polystyrene block and any material from
the drum.
• Before the first wash, run a cotton cycle at the highest
temperature without any laundry in the machine, to
Personalisation
Acoustic signals
The machine is provided with an acoustic device, which
sounds in the following cases:
• at the end of the cycle
• if there is a fault.
By pressing the 4 and 5 buttons simultaneously for about
6 seconds , the acoustic signal is deactivated (except if
there is a fault). By pressing these 2 buttons again, the
acoustic signal is reactivated.
Child safety lock
This device permits you to leave the appliance unattended
and not to worry that children might be injured by or cause
Daily use
Load the laundry
Open the door by carefully pulling the door handle out-
wards. Place the laundry in the drum, one item at a time,
shaking them out as much as possible. Close the door.
• Spin
By selecting the wash programme, the washing pro-
gramme phase icons corresponding to the various phases
making up the programme are shown in the upper part of
the display. After having pressed button 8 only the icon
of the running phase stays on.
7.13: Delay icon
The selected delay set by pressing the relevant button
appears on the display for a few seconds, then the duration
of the previously selected programme is displayed. The
relevant icon is lighted on. The delay time value decreases
by one unit every hour and then, when 1 hour remains,
the time decreases every minute.
remove any manufacturing residue from the drum and
tub. Pour 1/2 a measure of detergent into the main
wash compartment and start the machine.
damage to the appliance. This function remains enabled
also when the washing machine is not working.
There are two different ways to set this option:
1. Before pressing button 8 : it will be impossible to start
the machine.
2. After pressing button 8 : it will be impossible to
change any other programme or option.
To enable or disable this option press simultaneously for
about 6 seconds buttons 5 and 6 until on the display, the
icon
appears or disappears.
7
Advertisement
Table of Contents
