Installing Cpu - AOpen DXPL-U Installation Manual

Everything you need to boot
this motherboard is included in
this Easy Installation Guide.
For more information,
complete Online User's Manual
can be found in the Bonus
Pack. Thanks for the help of
saving our earth.
!
Screw Pack for I/O Port
!
Easy Installation Guide x 1
!
MB Layout and jumper setting sticker label x1
!
Ultra320 SCSI Cable x 1 (DXPL Plus-U only)
!
Floppy Cable x 1
!
IDE1 Cable x 1
!
IDE 2 Cable x 1 (DXPL-U only)
!
Bonus Pack CD x 1
!
Norton Anti-Virus CD x 1
!
I/O Port Bracket x 1
!
Floppy/IDE Cable Package
!
Plate plastic for retention module assembly x2
PART NO: 90.59F28.001 DOC. NO: DXPLPLUSU-EG-E0302A
a
Plug in the CPU fan cable to the 3-pin CPU FAN connector and housing fan cable to the Chassis Fan
connectors.
SENSOR
SENSOR

1. Installing CPU

CPU Pin 1 and cut edge
CPU socket lever
2. Installing CPU & Housing Fans
GND
+12V
CPU2 Fan
GND
+12V
Chassis Fan
SENSOR
+12V
GND
Chassis Fan
1.
Pull up the CPU socket lever and up to
90-degree angle.
2.
Locate Pin 1 in the socket and look for a
(golden) cut edge on the CPU upper interface.
Match Pin 1 and cut edge. Then insert the
CPU into the socket.
3.
Press down the CPU socket lever and finish
CPU installation.
Note: If you do not match the CPU
socket Pin 1 and CPU cut edge
well, it may damage the CPU.
CPU1 Fan
Chassis Fan
Note: Some CPU fans do not have sensor pin, so that
cannot support fan monitoring.
SENSOR
+12V
GND
GND
+12V
SENSOR