Configuring Recording Parameters - HIKVISION DS-7600NI Series User Manual

User Manual of DS-7600NI Series NVR

5.1 Configuring Recording Parameters

Purpose:
By configuring the recording parameters you can define the parameters which affect the image quality, such as the
transmission stream type, the resolution and so on.
Before you start:
1. Make sure that the HDD has already been installed. If not, please install a HDD and initialize it.
(Menu>HDD>General)
2. Check the storage mode of the HDD
1) Click Advanced to check the storage mode of the HDD.
2) If the HDD mode is Quota, please set the maximum record capacity. For detailed information,
see Chapter Configuring Quota Mode.
3) If the HDD mode is Group, you should set the HDD group. For detailed information, see
Chapter Configuring HDD Group for Recording.
Steps:
1. Enter the Record settings interface to configure the recording parameters:
Menu>Record> Parameters
Figure 5. 1 HDD- General
Figure 5. 2 HDD- Advanced
Figure 5. 3 Recording Parameters
57