Power Problems - HP 2000/5700 User Manual

If the display scrolls when the pointer reaches the edge
A high-resolution display setting is active. You can use a high-resolution external
display and turn off the OmniBook display by pressing Fn+F5, or you can choose
the default OmniBook display setting.

Power Problems

If you have power problems that interfere with turning on or starting the OmniBook,
see the troubleshooting chapter in the OmniBook Installation and Setup Guide, which
came with the OmniBook.
If the battery runs down too fast
Try conserving power using any of the suggestions listed under
power"
Check your power management settings using the
Make sure the OmniBook is set up so it can automatically change from Suspend
to Hibernate.
If the operating time has gotten shorter and the battery pack is more than a year
or two old, you may need a new battery pack.
If the OmniBook turns off immediately after it turns on
Battery power is probably extremely low. Plug in the ac adapter, or make sure
the OmniBook isn't turned on and insert a fresh battery—see
battery."
If the OmniBook doesn't suspend automatically
If the ac adapter is connected, the OmniBook doesn't suspend.
If you have a connection to another computer, the OmniBook doesn't suspend if
the connection is actively in use.
Check your power management settings using the
If the OmniBook doesn't turn on
Connect the ac adapter.
Press the blue On/Suspend button to try turning on the unit.
Try adjusting the display.
Reboot the OmniBook.
If you get no response, remove the battery and ac adapter and press the reset
button again—then install the battery or plug in the ac adapter and try resetting
again.
If the OmniBook doesn't turn on with a fresh battery
If the new battery pack is low, plug in the ac adapter.
If the OmniBook doesn't suspend immediately
"To save battery
System Configuration Utility.
"To replace the
System Configuration Utility.
64