(Location, availability, and number of connectors may vary.)
One Satellite Receiver (NTSC)
Connect the TV signal source from the satellite receiver
into the HP Digital Entertainment Center.
If you are using a satellite receiver (sold separately) with
S-video or composite video output, do the following:
1
Make sure that a coaxial cable connector from your
dish source is plugged into the satellite receiver In
connector.
2
Connect a video cable.
a
Choose a Video Out connector:
Coaxial (RF)
■
Video (composite)
■
S-video
■
b
Connect the video cable from the
satellite receiver back panel video output
connector.
c
Connect the video cable into the HP Digital
Entertainment Center back panel TV Source 1 In
connector.
Satellite Connection
3
Connect stereo audio cables (skip this step if using
coaxial [RF]):
a
From the satellite receiver back panel Audio Out
right (red) connector and Audio Out left (white)
connectors.
b
Into the HP Digital Entertainment Center back
panel TV Source 1 In Audio right (red) and Audio
left (white) connectors.
4
Connect the satellite receiver Infrared Transmitter
cable (required for signal). See "Infrared Transmitter
Connection" on page 97.
Connecting TV Source In
93