Summary of Contents for SeaLand VacuFlush 3600 Series
Page 1
Modification of this product can result in property damage. Dometic Sanitation Corporation 328 State Rt 226, PO Box 38 Big Prairie, OH 446 SeaLand Product Customer Service: -800-32-9886 (8:00 a.m. - 5:00 p.m. ET)
It will show the model number and serial number. P.O. BOX 38, 13128 STATE RT 226 (800) 321-9886 BIG PRAIRIE, OH 44611 USA MODEL NO. SERIAL NUMBER 000000 dometic, sealand, Vacuflush and flush and forget are registered trademarks of Dometic Corporation.
ImpoRTANT INFoRmATIoN beFoRe opeRATIoN 1. Fill freshwater tank and add deodorant to holding tank through toilet bowl. 2. Make sure all guests understand the operation of the toilet system and the flushing instruction label is easy for guests to read. This label is located under the seat, and is easily read when the seat is raised. 3.
opeRATING INSTRuCTIoNS 1. Adding more Water To Toilet bowl Press the “Add Water” switch until the desired water level is attained. To prevent overflowing the toilet, a timer limits the amount of water that can be added. 2. Flushing The Toilet When the flush panel’s green “OK to Flush”...
Restore the shine with this SeaLand cleaner. If you cannot find it in your area, contact Dometic for your nearest dealer. If the cleaner is not available, you can also use most...
MainTenanCe sChedUle Maintenance intervals and normal parts replacement vary widely depending on numerous factors such as frequency of system use, quality of flushing water, etc. The following chart is intended strictly as a general guide in keeping the sanitation system 100% ready for any conditions of use. Recommended Maintenance procedure parts Required...
Page 7
SANITATIoN SYSTem CompoNeNTS (cont’d) Vacuum Toilet: The 3600 series vacuum toilet with Flush and Forget technology operates in a way different from VacuFlush ® ® 3600 Series other marine toilets. Vacuum systems use a small amount Toilet of water (a little more than a pint or .5 liter) per flush in addition to a simple vacuum.
*Not included. oRDeRING pARTS Dometic is ready to assist you in the event service is required. Before calling, please have the following information available. Your cooperation in having this information ready is appreciated and allows us to better meet your needs.
3,500 pump-out stations, in total, will be added due to this legislation. Sewage from any source should not be discharged directly into our waters. If you are interested in learning more about this issue, please contact Dometic at the phone number or address listed on the back page of this manual.
FLuSH meCHANISm CompoNeNTS 3. Lift china toilet 1. To access flush straight up and set it mechanism compo- down close to front nents, remove decora- of mounting adapter. tive caps and unscrew Turn off water to toilet fasteners that hold china and disconnect flex- toilet to floor.
mANuAL FLuSH oVeRRIDe In the event of an electrical failure, the flush ball can be manually operated to clear the bowl. We recommend using a long-neck screwdriver or 7/16-in. socket for the operation shown below. NEVER PRY OPEN THE FLUSH BALL FROM INSIDE THE TOILET BOWL.
Page 12
TRoubLeSHooTING A volt/ohmmeter (VOM) and the Toilet Wiring Diagram may be required for this section. Caution: Portions of this section will require that power be applied to the toilet. Keep hands away from the flush ball, motor drive arm and rotor shaft to prevent personal injury during testing and troubleshooting. The control module uses a microprocessor to provide all the automatic and timing functions.
TRoubLeSHooTING (cont’d) eRRoR CoDe CoRReCTIVe pRoCeDuReS Condition Corrective Action Mode Switch in SERVICE position. Return Mode Switch to NORMAL position. Valve Open Limit Switch problem. With the flush valve fully open, check the “VALVE OPEN” status light. If the light is off, then the Valve Open Limit Switch is out of alignment or defective, or related wiring is defective.
Page 14
TRoubLeSHooTING (cont’d) SYmpTom 3. Flush valve will not close. Condition/Procedure Corrective Action • Return switch to the “Normal” position. Mode Switch is in SERVICE posi- tion: • Reset the control circuit by putting the Mode Switch in the SERVICE Foreign object prevents the flush position temporarily, then returning to the NORMAL position.
Page 15
TRoubLeSHooTING (cont’d) SYmpTom 8. Water will not stay in bowl and system loses vacuum. Condition/Procedure Corrective Action Put Mode Switch in “Service” • Clean underside of flush valve ball seal of dirt and debris. Position: Worn or damaged flush valve ball •...
They carry a complete p.m. (ET) Monday through Friday. You may also write us at inventory for the SeaLand product line. Dometic Corp., P.O. Box 38, Big Prairie Ohio 446. Telephone: 800-32-9886 U.S.A. and Canada Fax: 330-496-3097 U.S.A.
() year from the date of purchase. If this Dometic product is placed in commercial or business use, it will be warranted, to the original purchaser only, to be free of defects in material and workmanship for a period of ninety (90) days from the date of purchase.
Need help?
Do you have a question about the VacuFlush 3600 Series and is the answer not in the manual?
Questions and answers