¥ GF-BC, GF-VBC
GF-BC, GF-VBC
Screw (x2)
ON
Power
switch
OFF
Green LED lit
¥ GF-1D
It is suggested to mount the station at the height of 150cm (5') from the floor.
Service button
Handset
Light button
Door release
button
Screw
¥ GF-1MD
It is suggested to mount the station so that the video monitor comes at the user's eye level.
Handset
Plug
in
Modular
plug
Door release
button
1. Attach the mounting bracket to single-gang box.
2. Connect wires, and remount terminal block.
3. Mount GF-1MD on mounting bracket.
MOUNTING
Power
switch
Power on LED
(green)
HOW TO RESET BREAKER (Power switch)
When system malfunctions, check the wiring. Check the fuse of power supply.
Turn off the power switch of GF-BC & GF-VBC and turn on after 4 seconds.
Resets the whole system.
*1
Chassis
Cable
inlet hole
Single-gang box
83.5mm
(3-5/16")
*3
*1
*2
or round gang-box
Plug in
Modular
plug
Mounting bracket
Screw
or round gang-box
Service button
Light button
GF-BC,GF-VBC
1. Loosen a screw on front case.
Lift the front case off the chassis, and pull it away.
2. Mount chassis on box.
3. Connect incoming wires on terminal block.
4. Remount front case on chassis, tightening the screw.
60mm
(2-3/8")
Note;
Single-gang box
83.5mm
(3-5/16")
Unplug
Strip jacket of cables, and put all the wires neatly into
slot, otherwise damages the wires by pinching.
60mm
(2-3/8")
- 5 -
Mounting rail for GF-
BC, GF-VBC & GF-4Z:
W-DIN11 available
from Aiphone
Mounting rail
Notes;
1: Cut out a hole for surface cable run.
*
2: Terminal block & switch for SERVICE button
*
are optional.
3: To avoid pinching, keep wires away from PC
*
board section.
To detach;
Slide and pull out the
terminal block.
Need help?
Do you have a question about the GF-VBC GF-4Z and is the answer not in the manual?