Fine Tuning A Channel - HP PE4240N User Manual

6 Highlight and select To Be CH A or To Be CH B so it turns red. Adjust the setting so it reads YES to
select the channel (or NO), and then press Setting front panel button (Enter on the remote control).
7 Exit the menu.

Fine tuning a channel

1 Make sure TV is the input signal for the main picture. Refer to "Selecting the input source" on
page 26.
2 Display the OSD menus. Refer to "Using the On Screen Display (OSD) Controls" on page 28 for
steps to open and use the menus using the front panel buttons (or the remote control buttons).
3 Select and display TV Setup menu.
4 Highlight and select User CH so it turns red. Adjust the setting so it reads the channel number you
want to fine tune, and then press Setting front panel button (Enter on the remote control).
37
Using the TV