Connecting An Antenna Or Cable Tv; Connecting An Antenna Or Cable Directly To The Tv - HP PE4240N User Manual

Connecting an Antenna or Cable TV

Use the first procedure that follows when connecting an antenna or cable TV cable directly to the TV.
Refer to the next procedure, "Connecting a set-top-box to the TV" on page 16, when connecting a set-
top-box for cable or satellite. Refer to "Connecting a digital TV (DTV) receiver to the TV" on page 16
when connecting a digital TV receiver (DTV).

Connecting an antenna or cable directly to the TV

Use standard 75-ohm coaxial cable to connect a ground antenna or cable TV signal cable to the TV.
Use shielded coaxial cable to reduce radio frequency (RF) interference. To make this connection:
1 Turn off the TV.
2 Connect the antenna or cable TV coaxial cable to the TV antenna cable in connector on the back of
the TV.
3 Turn on the TV.
4 Select TV (the channel number) as the input source for the main TV picture by using the front panel
buttons or the TV remote control. Refer to "Selecting the input source" on page 26.
5 Perform the Automatic Channel Scan (auto scan) procedure; refer to "Run auto scan" on page 33.
This procedure includes the following tasks:
•
Selects Antenna or Cable for Signal Type in the TV Setup menu of the OSD menus.
•
Scans and identifies the available channels.
15
Set Up