HP PE4240N User Manual page 15

Item
A Main power
switch
B AC in connector
C RS232C
D Audio for DVI-D
connector
E DVI-D (29-pin)
input
F VGA, a D-sub
(15-pin) input
G Audio for VGA
connector
H External speaker
left and right
output
K Video Inputs
L Audio Output
M S-video Inputs
N Component Video
Inputs
P Audio for
component video
inputs connectors
R TV Antenna
Cable In
Description
Turns the AC power on and off. This switch is on from the factory. When this main power
switch is off, the TV is fully unpowered; the power/standby indicator light on the front of the
TV is off, and neither the front panel power button nor the remote control can be used to turn
on the TV. If you turn the main power switch off, wait at least 5 seconds before turning it on
again.
Connect the included power cord here.
This terminal is used for service only.
Connect the audio cable for the DVI-D input.
Connect a digital video cable for digital input signals from a PC monitor connector, or from
a digital cable or satellite receiver set-top-box. This connector supports HDCP, a form of copy
protection.
Connect an analog cable for input signals from a PC monitor connector. See your component
user documentation for information about the connector types it supports.
Connect the audio cable for the VGA input.
Connect the optional external speakers here, and then select external speakers in the OSD
menus.
Connect composite video cable and left-right audio cables for one or two devices such as a
VCR, a DVD player, or a laser disc player.
Connect audio out left-right cables to a powered amplifier.
Connect S-video cable and left-right audio cables for one or two devices such as a VCR, a
DVD player, or a laser disc player.
Connect cables for component video input.
Use YPbPr 1 for input from devices that support High Definition signals such as a progressive
scan DVD player, or a digital cable or satellite set-top-box. This connector supports 480p,
720p, and 1080i format video signals.
Use YPbPr 2 for input from devices that support component signals in 480i video format such
as a VCR, a DVD player, or a laser disc player.
Connect audio left-right cables for the YPbPr-1 input and the YPbPr-2 input.
Connect broadcasting (terrestrial) antenna or cable TV signal cable here.
11
Introduction