Connecting A Composite Video Source - HP PE4240N User Manual

6 For a set-top-box, perform these tasks:
•
Perform the Automatic Channel Scan procedure to establish the available channels. Refer to
"Run auto scan" on page 33.
•
To set up the TV remote control to operate the set-top-box, refer to "Programming the remote
control for component control" on page 53.
7 To have the TV screen turn off when there is no input signal on the DVI or VGA connector, change
the setting for Auto Off in the Function OSD menu. Refer to "Selecting Auto Off mode" on page 45.

Connecting a Composite Video Source

Use RCA cables to connect your composite video source, such as a VCR, to the TV.
To make these connections:
1 Turn off the TV and the VCR.
2 Connect one end of the RCA cable to the video output connector on the back of your VCR, and
connect the other end to the Video connector at the Video Inputs on the back of the TV. Use
standard RCA audio patch cords to connect the audio from your VCR to the TV (if your VCR has
this capability). Be careful to keep the audio right and left channel connections correct for stereo
sound.
3 Turn on the TV and the VCR. Insert a cassette into the VCR and play it.
4 Select Video 1 or Video 2 (AV) as the input source for the main TV picture (so you see the image
playing from the VCR) by using the front panel buttons or the TV remote control. Refer to "Selecting
the input source" on page 26.
5 To set up the TV remote control to operate the VCR, refer to "Programming the remote control for
component control" on page 53.
Refer to your VCR owner's manual for information about your equipment's video output requirements.
18
Set Up