Section 4 Setting Up - Windows; Installation Using Axis Print Utility For Windows - Axis 540 series User Manual

Section 4 Setting Up - Windows

Installation Using AXIS Print Utility for Windows

AXIS 540/640 User's Manual
Having connected the AXIS 540/640 to your network, this section
now describes how to set up your AXIS 540/640 for printing in the
Windows environment.
The following Windows platforms are supported:
• Windows 3.1 (requires add-on network support, see page 47)
• Windows for Workgroups
• Windows 95
• Windows NT
If you intend to use the AXIS 540/640 in a multiprotocol
environment, you should also proceed to other relevant sections in this
manual, namely:
Section 3 Setting Up - NetWare
Section 5 Setting Up - OS/2
Section 6 Setting Up - Macintosh
Section 7 Setting Up - UNIX
Section 8 Web Based Management
Unless you wish to change the default name of your AXIS 540/640,
the setup operation may be performed solely with the AXIS Print
Utility for Windows, which is supplied on the AXIS Utilities disk.
You should install this utility now if you have not already done so - see
the instructions on the AXIS Utilities disk label.
If you wish, you may change the default name of your AXIS 540/640
or amend any of the default parameters, using the AXIS NetPilot, or
any standard Web browser. Refer to Section 8 - Web Based
Management.
Section 4: Setting Up - Windows
45