Setting Up - Netware; Section 6 Setting Up - Netware - Axis 5400+ User Manual

Setting Up - NetWare

Section 6 Setting Up - NetWare
38
This section describes how to continue the installation of the AXIS 5400+/AXIS
5600+ in the NetWare environment. Identify which transport protocol you are
running on your network and which installation method you should use.
Continue the installation by selecting the appropriate installing instructions
from the table below:
Installation Transport
method protocol
NDPS TCP/IP
IPX/SPX
iPrint iPrint over LPR
iPrint over IPP
Queue-based IPX/SPX
printing
Basic
Configuration
IPX/SPX
Advanced
configuration
See "NetWare Administration" on page 64. for information on Novell's
administration tools.
If you intend to operate your AXIS 5400+/AXIS 5600+ in a multi-protocol,
mixed environment, you should also proceed to the other relevant sections in
this manual.
Action
See "Setup using NDPS" on page 39.
- Public Access Printers, on page 40
- Controlled Access Printers, on page 44
See "Setup using iPrint" on page 53.and
See "Install a printer using AXIS LPR Gateway Configuration
Snapin" on page 55.
See "Setup using iPrint" on page 53.and
See "Install a printer with AXIS IPP Gateway Configuration
Snapin" on page 55.
To install using the AXIS NetPilot Installation Wizard,
See "Basic Setup with AXIS NetPilot" on page 58..
If you need a more advanced installation that is not covered by
the AXIS NetPilot Installation Wizard,
See "Advanced Installation using AXIS NetPilot" on page 60..
AXIS 5400+ / AXIS 5600+ User's Manual