Basic Set Up Of The Network - Axis 540 series User Manual

Section 2: Basic Installation

Basic Set Up of the Network

Installation Guide
NetWare
UNIX
Windows
OS/2
Macintosh
20
After connecting the AXIS 540/640 to your network you are now
ready to perform the basic setup procedures. The method of
installation that you choose should be dictated by your printing
requirement and the type of network into which you are integrating.
Proceed with an appropriate installation method from the list below:
• If you have access to a Windows platform which uses NetWare
you should firstly follow the procedures defined in:
- Basic Set Up with AXIS NetPilot, on page 22.
- Section 3 Setting Up - NetWare
• Perform the basic TCP/IP set up procedures if your network uses
UNIX workstations, as defined in:
- Basic Set Up for TCP/IP, on page 25.
- Section 7 Setting Up - UNIX
• If your Windows platform uses NetBIOS/NetBEUI, use the
NetPilot only if you want to change the default print server name.
If this is unnecessary, proceed directly to:
- Section 4 Setting Up - Windows
If your Windows platform uses neither NetWare nor NetBEUI,
you must initially perform the basic TCP/IP set up procedures, as
defined in:
- Basic Set Up for TCP/IP, on page 25.
- Windows NT LPD Printing, Section 4
• If your network uses OS/2 workstations, use the NetPilot only if
you want to change the default print server name. If this is
unnecessary, proceed directly to:
- Section 5 Setting Up - OS/2
• If the only workstations on your network are Apple computers,
you should refer directly to:
- Section 6 Setting Up - Macintosh
AXIS 540/640 User's Manual