Starting The Program; Progress Of Program; Changing The Program After The Program Has Started - Blomberg TROCKNER TKF 7330 A User Manual

detected by sensors during a drying
cycle and the remaining time is
updated automatically.
Canceling the time delay
If you want to cancel the time delay
countdown and start the program:
1. Press the "Start/Pause/Cancel"
button for about 4 seconds. The ":"
in the middle of the screen will stop
flashing. The "Start/Pause/Cancel"
light will go off and the remaining time
on the screen disappears.
2. Press the "Start/Pause/Cancel"
button to start the program right
away.

Starting the Program

1. Press the "Start/Pause/Cancel"
button to start the program.
2. The "Start/Pause/Cancel" button will
light up to indicate that the program
has started.

Progress of program

Progress of a running program is shown
through the program follow-up indicator.
At the beginning of every program step,
the relevant indicator lamp will light up
and light of the completed step will turn
off.
"Drying":
- Drying level will be illuminated during
the whole drying process until the drying
degree reaches "iron dry".
"Iron Dry":
- Starts to illuminate when the drying
degree reaches "iron dry" step and
remains illuminated until the next step.
"Cupboard Dry":
- Starts to illuminate when the drying degree
reaches "Cupboard dry" step and remains
illuminated until the next step.
"Cooling":
- It lights up during the 4-minute cooling
phase at the end of drying.
"Final / Anti-creasing":
- Illuminates when the program comes
to an end and anti-creasing function is
activated.
Important:
If more than one LED light up or
flash concurrently, it means there is
malfunctioning or a failure (please see,
Solution suggestions for problems).
Changing the program after the
program has started
You can use this feature after your machine
has started to dry your clothes under higher
or lower temperatures.
For example;
Press and hold the "Start/Pause/Cancel"
button for about 4 seconds to "Cancel"
the program in order to select "Extra Dry"
program instead of "Iron Ready" program.
Select the "Extra Dry" program by rotating
the program knob.
Press the "Start/Pause/Cancel" button to
start the program.
C
The program which is selected first will
go on even if the program selection
button is moved and another program
mode is selected while the machine is
operating. You must cancel the ongoing
program in order to change the drying
program. (See, Ending the program
through canceling)
Adding/removing laundry in standby
mode
In order to add or take out laundry after the
start-up of the program;
1. Press the "Start/Pause/Cancel" button
to switch the machine to "Pause" mode.
Drying process will stop.
2. Open the door at Stop position and
close it again after adding or taking out
laundry.
3. Press "Start/Pause/Cancel" button to
start the program.
C
Any laundry added after the drying
process was started may cause the
already dried clothes in the machine
intermingle with wet clothes and the
15 - EN