Connection To A Water Drain (For Products Equipped With A Condenser And Heat Pump) - Blomberg TROCKNER TKF 7330 A User Manual

plastic covers.
2. Connect the air outlet hose to
the hose spacer piece (90° or flat
adaptor) by turning it anti-clockwise.
3. Make the hose passages as shown
below.
C Exhaust of humid air from the dryer
into the room is inconvenient. It may
damage the walls and furniture in the
room.
C The ventilation hose can be routed
outdoors via a window or it can be
connected to the air outlet in the
bathroom.
C Air outlet hose must be extended
directly to the outdoors. There must
be a small number of elbows as not
to hinder air ventilation.
C To prevent water accumulation in the
hose, make sure that it is not folded
on the floor.
B The air ventilation hose should not be
connected to the chimney of a stove
or a fireplace.
B Do not operate your machine at the
same time with heaters such as a
coal or gas stove. Airflow may cause
the chimney to flare up. Airflow may
cause the chimney to flame up.
Connection to a water drain
(for products equipped with a
condenser and heat pump)
In products equipped with a condenser
unit the water accumulated during the
drying cycle is collected in the water tank.
You should drain the accumulated water
after each washing cycle.
You can directly send the accumulated
water out through the water drain hose
supplied with the machine instead of
periodically draining the water collected in
the water tank.
Connecting the water drain hose;
1. Remove the hose on the machine by
pulling it out from its end. Do not use
any tools to take out the hose.
2. Connect the special drain hose
supplied with the machine to the pipe
fitting.
3. The other end of the drain hose
can be directly connected to
the wastewater drain or to the
washbasin. The fitting must always be
secured in all types of connections.
Your house may be flooded if the
hose gets out of its housing during
water discharge.
C When you direct the water drain out,
"Water Tank" warning LED will light
up at the end of each program.
Important:
• The hose should be attached to a
height of maximum 80 cm.
• You must be careful not the pinch or
bend the hose.
• The end of the hose should not be
bent, it should not be stepped on and
7 - EN