Starting The Program; Progress Of Program; Changing The Program After The Program Has Started; Iron Dry - Blomberg TKF 7350 User Manual

Canceling the time delay
If you want to cancel the time delay
countdown and start the program:
1. Press the "Start/Pause/Cancel" button
for about 4 seconds. The ":" in the
middle of the screen will stop flashing.
The "Start/Pause/Cancel" light will
go off and the remaining time on the
screen disappears.
2. Press the "Start/Pause/Cancel" button
to start the program right away.

Starting the Program

1. Press the "Start/Pause/Cancel" button
to start the program.
2. The "Start/Pause/Cancel" button will
light up to indicate that the program
has started.

Progress of program

Progress of a running program is shown
through the program follow-up indicator.
At the beginning of every program step,
the relevant indicator lamp will light up and
light of the completed step will turn off.
"Drying":
- Drying level will be illuminated during
the whole drying process until the drying
degree reaches "iron dry".

"Iron Dry":

- Starts to illuminate when the drying
degree reaches "iron dry" step and remains
illuminated until the next step.
" Cupboard Dry":
- Starts to illuminate when the drying degree
reaches " Cupboard dry" step and remains
illuminated until the next step.
"Cooling":
- It lights up during the 4-minute cooling
phase at the end of drying.
"Final / Anti-creasing":
- Illuminates when the program comes
to an end and anti-creasing function is
activated.
Important:
If more than one LED light up or flash
concurrently, it means there is malfunctioning
or a failure (please see, Solution
suggestions for problems).
Changing the program after the
program has started
You can use this feature after your machine
has started to dry your clothes under higher
or lower temperatures.
For example;
Press and hold the "Start/Pause/Cancel"
button for about 4 seconds to "Cancel"
the program in order to select "Extra Dry"
program instead of "Iron Ready" program.
Select the "Extra Dry" program by rotating the
program knob.
Press the "Start/Pause/Cancel" button to
start the program.
C
The program which is selected first will
go on even if the program selection
button is moved and another program
mode is selected while the machine is
operating. You must cancel the ongoing
program in order to change the drying
program. (See, Ending the program
through canceling)
Adding/removing laundry in standby
mode
In order to add or take out laundry after the
start-up of the program;
1. Press the "Start/Pause/Cancel" button
to switch the machine to "Pause" mode.
Drying process will stop.
2. Open the door at Stop position and close
it again after adding or taking out laundry.
3. Press the "Start/Pause/Cancel" button to
start the program.
C
Any laundry added after the drying
process was started may cause the
already dried clothes in the machine
intermingle with wet clothes and the
result will be wet laundry after the drying
process is over.
C
Laundry may be added or taken out
as much as desired during a drying
process, but as this process will interrupt
drying continuously, it will extend
the program duration and increase
energy consumption. Therefore, it is
recommended to add laundry before the
drying program is started.
15 - EN