Description; Model Summary; Installation; Operating Voltage - Bosch UNPXF Series Instruction Manual

Unity prepackaged cameras
Table of Contents

Advertisement

UNPM, UNPC, UNPDN, UNPXF Series | Instruction Manual | Description
3.0

DESCRIPTION

The UNPM Series, UNPC Series, UNPDN Series,
and UNPXF Series are complete camera packages that
include a camera/lens pre-wired into a housing. A
feed-through wall mount is also provided, as well as a
sunshield on outdoor packages.
3.1

Model Summary

Refer to APPENDIX A for the resolution, lens, and
system specifications for the various package models.
4.0

INSTALLATION

WARNING: This installation should be made
by a qualified service person and conform to
all local codes.
4.1

Operating Voltage

All Recommended operating voltage is
24 VAC, 60 Hz.
4.2

Preparing the Unit

Remove the mount and the housing assembly from the
carton.
4.3

Mount

Prepare and secure the mount to the wall or mounting
surface as described in the LTC 9215/00 Installation
Manual included in the Instruction Booklet Packet.
4.4

Housing

Feed the cabling from the housing foot through the
mount. Attach the housing to the mount using the
two (2) M6 screws and washers provided in the
hardware kit. For additional information, refer to
the LTC 9215/00 Mount Installation Manual and
HSG9483 Series Housing Installation Manual.
Bosch Security Systems | May 5, 2006
4.5
Line Power and Video Signal
Connection
The external video coax cable is equipped with a
female BNC connector for transmission of video.
Route and connect video cable to the BNC connector.
The external power cable is provided to allow for
necessary stripping/preparation by the installer. For
additional information, refer to the Installation
Manuals included in the Instruction Booklet Packet.
4.6
Connections for F Suffix and
N suffix Cameras
The connections for models containing fiber optic or
twisted pair interfaces are covered in a separate
Installation Instruction Addendum that is provided
with those model types.
5.0
CAMERA/LENS
ADJUSTMENT
The camera and lens come factory configured and
ready for operation. If custom setup is required, refer
to the camera Installation Instructions included in the
Instruction Booklet Packet.
Outdoor models that include the LTC 3374/50
5-50 mm lens are supplied with a lens support bracket
that protects the lens during shipment. If necessary,
this bracket can be removed to allow access for lens
adjustment. To remove the bracket, cut the cable tie
and remove the screw as shown in the photo below.
6.0

SUNSHIELD

A sunshield is provided with the outdoor packages.
EN | 8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Unpm seriesUnpc seriesUnpdn series

Table of Contents