Bradford White POWERED DIRECT VENT SERIES GAS-FIRED COMMERCIAL WATER HEATER Installation & Operation Manual page 28

TO INCREASE SETPOINT TEMPERATURE
Step 1: Depress and hold "Temperature Up" button until desired setpoint temperature appears in the display.
Step 2: "Setpoint" indicator begins flashing in the display after pressing "Temperature Up" button.
Step 3: Press "SET" button for new setting to take effect immediately. "Setpoint" will stop flashing. If the "SET" button is
not pressed, the new temperature setting will take effect in approximately 10 seconds.

°F
idle
Operational
Status
SELECT SET
Step 1

setpoint
°F
idle
Operational
Status
SELECT SET
Step 2
setpoint
°F
idle
Status Operational

SELECT SET
Press SET Button for setting to
Step 3
to take effect immediately
28
"Setpoint"
flashes
"Setpoint" flashes
for 10 seconds