Advertisement
Remove the panel
1. Press the PWR button to turn the power off.
2. Press OPEN button to detach the panel.
3. Pull the panel out.
4. Place the panel into the case and take it with you when you leave the car.
Remove the unit
1. Remove the panel and the trim plate.
2. Insert both T-Keys into hole on the front of the set until they lock.
3. Pull out the unit.
NOTE:
The source unit will turn off if the control panel is open longer than 60 seconds.
The LED light on the inner panel will twinkle in red when the ACC power is cut off.
Troubleshootin guide
Symptom
Cause
Solution
If the power supply is properly connected
General
The car ignition is not on.
to the car accessory switch the ignition
No power
The fuse is blown.
key to "ACC".
Replace the fuse.
Volume is in minimum.
Adjust volume to a desired level.
No sound
Wiring is not properly
connected.
Check wiring connection.
The operation
The built-in microcomputer
is not operating properly
Press the RESET button.
keys do not
due to noise.
Reinstall the front panel.
work.
Front panel is not properly
fixed into its place.
The radio does
not work; the
The antenna cable is not
Insert the antenna cable firmly select a
radio station
automatic
connected the signals are
station manually.
selection does
too weak.
not work.
17
Advertisement
