Slot 4 Connector Figure 2 * This enclosure was originally designed for use with SCSI drives; the unused drive activity LED’s indicated data reads and writes. Serial ATA does not support drive activity sig- nals, so Fusion 400’s LEDs just light up.
Page 3
(even the bottom of each remov- functioning, contact Sonnet Customer Service. able tray is perforated for air flow) to make Fusion 400 a cool run- ning solution—the lower the drives’ temperature, the lower the •...
Drive Installation and Enclosure Setup 1. Remove the Fusion 400 from its packaging, and place the enclo- sure near the computer to which it will be connected. 2. Remove a drive tray from the enclosure by pulling on its lever, and then sliding it out.
• Product name Connections: • Date and place of purchase Fusion 400 uses eSATA data cable connectors to ensure the best connection. If you experience issues where a drive or volume • Hard drive model(s) does not appear, or you see an error message stating a drive is missing when you have the drives set up in an array, the cause •...