Four winns FREEDOM Owner's Manual page 145

Figure S2: Trailer Tongue Assembly
To pivot the tongue on trailers models with hinge located
inside the receiver:
1. Make sure the trailer jack is supporting the trailer
load properly. Refer to Section S-2C on Swivel Jacks
for additional information.
2. Unplug the wire harness at the trailer cross member.
3. Disconnect the brake line coupler.
4. Remove the locking hair pins and clevis pins. Please
note, the locking hair pins must be rotated away
from clevis pin and then removed.
NOTICE
The tongue will exert some pressure on the clevis
pins. It may be necessary to lift, push or wiggle
the tongue to remove the clevis pins.
5. Slide trailer tongue out of receiver until the hinge is
exposed. Pivot the tongue towards the trailer as
far as it will go.
To reinstall, follow this procedure in reverse order.
1. Pivot the tongue so that it extends straight and is in
alignment with the receiver.
NOTICE
When extending tongue ensure that the brake
line and wire harness are not pinched. Failure
to check could result in damage.
Freedom™/Horizon™ Owner's Manual
™
2. Slide the trailer tongue into the receiver until the
clevis pin holes are aligned.
3. Insert clevis pins with washers and locking hair pins.
NOTICE
The tongue will exert some pressure on the clevis
pins. It may be necessary to lift, push or wiggle
the tongue to insert the clevis pins.
4. Reconnect the brake line coupler.
5. If towing the trailer, remember to plug the 5-wire
tongue harness to the trunk connector wire harness
of your tow vehicle.
Make sure the trailer tongue is secure before
hitching to the towing vehicle.
To pivot the tongue on trailers models with exposed
hinges:
1. Make sure the trailer jack is supporting the trailer
load properly. Refer to Section S-2C on Swivel Jacks
for additional information.
2. Unplug the wire harness at the trailer cross member.
3. Disconnect the brake line coupler.
4. Remove the clevis pin keeper and clevis pin.
NOTICE
The tongue will exert some pressure on the clevis
pins. It may be necessary to lift, push or wiggle
the tongue to remove the clevis pins.
5. Pivot the tongue towards the trailer as far as it will
go.
To reinstall, follow this procedure in reverse order.
1. Pivot the tongue until the clevis pin hole is aligned.
NOTICE
When extending tongue ensure that the brake
line and wire harness are not pinched. Failure
to check could result in damage.
Section S
Page 3