Connecting With A Multiplexer; Updating System Software - Sony MPEG4 LAN Camera Installation & Operation Manual

1/3" sony super had ccd
Table of Contents

Advertisement

3.3 CONNECTING WITH A MULTIPLEXER

3.4 UPDATING SYSTEM SOFTWARE

If the system software of the LAN CAMERA needs to be upgraded, please take the following
steps to safely process it.
Important: Before carrying out the following procedures, please ensure the SD card is
working and the file of the system firmware is intact
1. Format an SD card using the FAT16 format if it is unformatted; there are no limitations to an SD
card's capacity.
2. Create a directory named LANCAM in the SD card if it does not exist.
3. Copy the file of UPDATE.BIN to the LANCAM-directory.
4. If the LANCAM is running, please power it off first.
5. Insert the SD CARD into the LANCAM.
6. Remove the Ethernet cable from the RJ-45 port and then power on the LANCAM.
7. In 5 to 10 seconds, a message reading "UPDATE PROCESSING" will show up on the screen on
a blue background; if not, please check out steps 1 to 6 carefully or else inform your technical
support while ignoring the following steps.
8. DO NOT power off the LANCAM while this update process is running until the message
"UPDATE OK RESET PLEASE" appears on the screen; it might take 15 to 30 seconds to
appear.
TO LAN CAMERA VIDEO OUT BNC CONNECTOR
13
LAN CAMERA 1
LAN CAMERA 2
LAN CAMERA 16

Advertisement

Table of Contents
loading

Table of Contents